<ruby id="bhvdj"></ruby>
    <address id="bhvdj"><listing id="bhvdj"><listing id="bhvdj"></listing></listing></address>

    <address id="bhvdj"></address>
    <address id="bhvdj"><listing id="bhvdj"><meter id="bhvdj"></meter></listing></address>
    <span id="bhvdj"><pre id="bhvdj"><ol id="bhvdj"></ol></pre></span>
    <noframes id="bhvdj">
    <form id="bhvdj"><th id="bhvdj"><meter id="bhvdj"></meter></th></form>

    <form id="bhvdj"><listing id="bhvdj"><menuitem id="bhvdj"></menuitem></listing></form>

    <sub id="bhvdj"><listing id="bhvdj"><menuitem id="bhvdj"></menuitem></listing></sub>
    <form id="bhvdj"></form>

    <noframes id="bhvdj"><form id="bhvdj"><nobr id="bhvdj"></nobr></form>
      <em id="bhvdj"></em>
      Beier Machinery specialize in providing you with plastic recycling machine for PE,PP,PET,film,plastic granulator,plastic pelletizer.
      You are here: Home ? News ? Precautions Before and After the Use of Plastic Pelletizer
      Precautions Before and After the Use of Plastic Pelletizer

      What are the precautions before and after the use of plastic pelletizer?
      1. Adjust the proper distance between the granulator and the screen of the plastic pelletizer. Generally, the closer the better, the better the normal operation will not touch the granule.
      2. Before working, check whether the plastic granulator screen ring is fixed. Is the screw on the granulating knife fastened, loose or not, and is the mesh of the screen clean?
      3. Let the plastic pelletizer run normally for a few minutes, is it working properly? Start slowly feeding, Note: There should be no hard materials in the added materials, especially hard materials. Adjust the appropriate speed according to the viscosity of the material. If the viscosity is high, turn the speed down, try not to shake the sieve in the process.


      4. If the mesh does not discharge during work, the mesh of the screen may have been blocked. Remove the screen and clean it. If it is not working after a certain period of time, wait for the next work. The screen is cleaned before it can work, so that the powder is not blocked in the mesh, so it is easy to squeeze the screen.
      5. Air-cooling and water-cooling are turned on according to the material characteristics. If it is sensitive to heat, the component will be slightly larger, and the heat-insensitive opening will not open.
      6. The plastic granulator should be completely maintained for 3 months, and the oil of the reducer should be replaced and replaced with new mechanical oil.
      7. After each work, thoroughly clean the plastic granulation mechanism granules and granules, and dry them with a dry cloth.
      8. When the plastic granulator is working or cleaning, the material cannot be dropped into the inverter panel, which makes it easy to damage the inverter panel. Slow speed regulation when speed regulation.

      Category: News

      Make an Enquire

      Your email address will not be published. Required fields are marked *